temperature humidity vibration combined
Performance indicators:
1.Temperature range: -40 celsius degree ~ 150 celsius degree
(depending on the customer needs to select the temperature)
2.Humidity range: 20 ~ 98 percent R.H
3.Fluctuations / uniformity: less than about 0.5 celsius degree /
less than about 2 celsius degree
4.Humidity deviation: +2, -3 percent R.H
5.Heating rate: 1.0 celsius degree ~ 3.0 celsius degree / min
6.Cooling rate: 0.7 celsius degree ~ 1.0 celsius degree / min
7.Power supply voltage: AC380V about 10 percent 50 about 0.5Hz
three-phase five-wire system
8.Ambient temperature and humidity: RT: 5 celsius degree ~ +30
celsius degree less than 98 percent RH
Operation control system:
1.Controller: imported microcomputer temperature and humidity
integrated controller
2.Accuracy Range: Setting Accuracy: Temperature about 0.1 celsius
degree, humidity of about 1 percent RH, indicating accuracy:
temperature about 0.1 celsius degree, humidity of about 1 percent
RH
3.Temperature and humidity sensors: platinum resistance PT100Ω/mV
4.Heating system: fully independent system, electrically heated
nichrome heater
5.Humidification system: External isolated, stainless steel surface
by evaporative humidifier
6.Dehumidification System: The dew point temperature of the
evaporator coil layer contact with dehumidification
7.Water System: automatic humidification control and recyclable
water than water saving water.
8.Cooling System: TEFC single compression refrigeration mode, the
original French "Taikang", totally enclosed fan cooled repetition
compression refrigeration
9.Circulatory system: high-temperature low-noise air-conditioning
motors multi-vane centrifugal wind wheel
10.Security: low temperature and humidity chamber with leakage,
short circuit, over-temperature, water, motor overheating,
over-current protection / controller power failure memory function
material:
1.Carton Material: high quality carbon steel phosphate
electrostatic spray treatment SUS304 stainless steel matte lines
hairline treatment
2.Within the box material: SUS304 stainless steel high-quality
mirror light board
3.Insulation Material: polyurethane rigid foam, ultra-fine glass
fiber cotton
4.Door insulation: double temperature aging silicone rubber door
seal
Meet the standard:
GB/T10589-1989 temperature test chambers;
GB/T10586-1989 damp heat test chambers;
GB/T10592-1989 high temperature test chambers;
GB2423.1-89 Low Temperature Test Aa, Ab;
GB2423.3-93 (IEC68-2-3) Damp heat test Ca;
MIL-STD810D Method 502.2;
GB/T2423.4-93 (MIL-STD810) Method 507.2 Procedure 3;
GJB150.9-8 damp heat test;