Steel Round Rebar Cutting And Bending Machine Efficient Manual
GQ40 , GQ50 cutting machine for rebar splicing is produced
according to JG/T5085-1996 standard. It can be applied to cut the
plain carbon steel, hot rolled steel and deformed bar in the
reinforced concrete structure for construction projects, but also
suit for square steel,flat steel and angle steel. The machine is an
ideal equipment for cutting, and widely used in machine processing
industry, it has the following advantages:
1. Small volume, compact structure, solid and reliable.
2. Good lubricating property, adopt enclosed gear box, use the gear
splashing to realize lubrication. It could be continuous work over
one month.(oil level should not be below oil marking line, so that
guarantee machine keeps in good lubrication condition).
3. Less functional loss because of the lubrication improvement. The
gear section adopts rolling bearing, less resistance. Compared with
same type cutting machine, it has a significant reduction in load
4. Easy to move, flexible, and convenient to maintenance.
5. The end face cut by this machine is vertical, round, flat and no
Main Technical Parameters
Cutting Rebar Diameter Range: 14mm-28mm (GQ50) 14mm-32mm (GQ40)
Cut Flat Steel(max): 70mm×15mm (GQ40) 85mm×16mm (GQ50)
Cut Square Steel(max): (Q235-A)32mm×32mm (GQ40)
(Q235-A) 40mm×40mm (GQ50)
Cut Angle Steel(max): 50mm×50mm (GQ40),63mm×63mm (GQ50)
Cutter Nominal Stroke: 34mm
Punching Frequency: 32times/min
Motor Power: 3.0KW(GQ40) 4KW(GQ50)
Motor Speed: 2880r/min
Weight: 430kg±5kg (GQ40) , 530kg±5kg (GQ50)
Specification of efficient rebar cutter/ manual steel bar cutter/
steel round bar cutting machine:
|Cutting Range||Common Round Steel||Φ6-Φ40mm|
|Grade III Deformed Bar||Φ6-Φ30mm|
Features of cutting machine, steel cutting machine, bar cutting
1. Move easily. small size, compact structure, solid fuselage. With scrollable
casters it can be moved easily and flexibility.
2. Good lubricating properties.It adopts full close structure and lubricates by using gears splash.It can operate more than three months continually if it is
added oil(8-10kg) at a time.
3. Little power loss.For lubrication conditions improving,gear-side uses rolling
bearing,the resistance is small,compared with the similar cutting
machine with load power can reduce by one third.
4. Work longer.It adopts the high steel knife block,connecting rod,high-speed
international standard motor,its quality is more stable and it will
5. High rigid cutting head. connecting rod and high speed national standard motor, guaranteed
a more stable quality and longer service life.