4mm-15mm Thickness Waste Gas Treatment Flue Gas Acid Fume Wet Scrubber Purification Tower

High quality waste gas treatment wet scrubber dust collector

This products can be customized. Such as the size, material, packing material, motor voltage, pipeline. It will be helpful if you can provide the information below:

1.The waste gas information. Such as the composition and concentration, the temperature when it enters the wet scrubber. If you have the gas test report, that is better. These will help us to determine the material.

2. the air volume. If you wanna purify the whole room, tell me the L*W*H. If you wanna collect the waste gas/ fume from several points, tell me the points L*W.
3. The voltage you need. Single-phase and three-phase are both needed.

4. Some pictures and videos of the workshop and machine.

5. If you need us provde the pipeline, show me the drawing or machine layout.

With above information we can make design and quote exact price immediately.

The exhaust gas is introduced into the purification tower by the wind pipe. Through the packing layer, the exhaust gas and the absorption liquid are fully exposed to the absorption and neutralization reaction of the gas-liquid two phase. After the exhaust gas is purified, the fan is discharged into the atmosphere by the dehydration of the mist removal plate and the mist eliminator. The absorption liquid is pressurized by the pump at the bottom of the tower and then sprayed down at the top of the tower. Finally, it is recycled to the bottom of the tower for recycling. The purified acid mist exhaust gas is lower than the national emission standard.

Specification sheet:

Application pictures:

Adventages:

1.The efficiency of dust removal and desulfurization is high and the efficiency of desulfurization can reach 85% when using alkaline washing water.
2.The wet scrubber dust collector is small and easy to install.
3.Low water consumption and low power consumption.
4.The equipment is reliable, simple and convenient to maintain.